KisanKrete emblem: a rice stalk and city buildings in a gold and grey circle KisanKrete

A mineral floor coating for floors where epoxy fails.

Built for heat, chemical spills and slab moisture. Applied by your existing flooring crew.

KisanKrete sample panel, light grey finish KisanKrete sample panel, terracotta finish KisanKrete sample panel, charcoal finish KisanKrete sample panel, yellow ochre finish
KisanKrete sample panels.

The problem

Where epoxy fails.

Heat

Hot process areas soften polymer films.

Chemical spills

Acids and solvents attack the coating.

Slab moisture

Vapour from the slab lifts and blisters the film.

Yellowing

Floors look worn long before they are.

Recoating downtime

Every recoat shuts an area down for days.

Sound familiar?

Tell us about your floor.

Proof so far

Tested in the lab. Ordered by manufacturers.

A torch flame applied to a KisanKrete sample block
Torch test on a KisanKrete sample.
>1.5MPa Pull-off adhesion, Day 28
Acid resistance Lab tested
Fire exposure Lab tested
2 Signed Letters of Intent
2 Paid pilot orders
3 Expressions of interest

Want the test details? Ask us.

How to start

Start small.

  1. 01

    Sample panel

    See and test the surface yourself.

  2. 02

    Pilot area

    Your crew applies it on a small area, with our guidance.

  3. 03

    Roll out

    Scale up once you have seen it perform.

Questions

Frequently asked.

What is KisanKrete?

KisanKrete is an industrial mineral floor coating made with silica we produce from raw rice husk. It is designed as an alternative to epoxy for floors exposed to heat, chemical spills and moisture from the slab.

How is it different from epoxy?

Epoxy is a polymer film on top of the concrete. KisanKrete is a mineral coating, built for the conditions where epoxy films soften, blister, yellow or need frequent recoating.

Can our existing flooring crew apply it?

Yes. KisanKrete is applied with standard tools and standard surface preparation, with guidance from our team.

Has it been tested?

Yes. KisanKrete showed pull-off adhesion above 1.5 MPa at Day 28 in lab testing, and has been lab tested for acid resistance and fire exposure. Contact us for the test details.

How do we start?

Request a sample panel to inspect, then run a small pilot area in your plant before any wider rollout.

See it on your own floor.

Start with a sample panel to inspect, or a small pilot area in your plant.

Request a call back

Leave your number and we will call or WhatsApp you.

We use your details only to get back to you.